GlowShift Gauges Support Center
Submit a request Sign in
How can we help?
  1. GlowShift Gauges Support
  2. 1992 - 1997 Ford F-Series Installation
  3. FAQs

FAQs

Follow New articles New articles and comments
  • Do I have to remove my A-Pillar to Install GlowShift Pillar Pod?
  • Is there a particular spot on the intake Spyder that I should drill and tap?
  • Which Boost Installation method is more accurate, Drilling and Tapping, or ‘T’ing into the MAP line?
  • Do I have to use Teflon Tape?
  • How tight should the ferrule cap be on the boost line fitting?
  • What are some suggestions to avoid pinching or kinking the boost hose?
  • Is it necessary to jack up the vehicle and remove the front passenger wheel?
  • What happens if I install the EGT probe after the turbo?
  • I had planned on installing the probe farther down the exhaust pipe, why would this be inaccurate?
  • How much should I tighten the EGT probe fitting?
  • Is there a particular type of anti seize I should use?
  • How deep should my EGT probe be into the manifold?
  • Will the sensor wires reach my mounting location?
  • Is this location the most accurate reading?
  • My EGT harness is different than depicted in this installation guide, what do I do?
  • Does the Steel Braided Cable have to be away from direct heat?
  • I have the 3 or 4 Gauge Wiring Kit. Am I supposed to use the green wire that came with this to install the transmission temperature sensor?
  • What color is the signal wire on the transmission temperature gauge?
  • Is there another way I could install the Transmission Temperature Sensor?
  • Should I use Teflon Tape, or thread sealant when installing the sensor directly to my fuel filter housing?
  • How do I know whether or not I will need a thread adapter to install the sensor into my fuel filter housing?
  • Is there another way I could install the fuel pressure sensor?
  • Do I have to use the expandable circuits?
  • Where is the best place to connect the ground wire?
  • Is there another fuse I can utilize other than the fuse places mentioned in the instructions?
  • Can I attach the dimmer wire to the adjustable light dimming settings used for the lighting in the cabin of the vehicle/dash?
  • Where are the best locations to install the screws to secure the pod?
  • What if the pod is not sitting correctly?
  • I have finished the install, and checked for loose connections and leaks - but the gauges are still not powering on. What should I do?

Copyright © GlowShift Gauges, LLC.

Theme by